Ive taken a closer look at the connector of the cord and cant see that it makes a differnce regard the black pair being installed as pins 1-2 or pins 7-8. Regards polarity in general, the umbilicle cord between the BC6 and the ALIGN card consists of 8 wires, 6 red and 2 black.
The 2 boards each had there own cable to connect to the charger, the polarity is opposite on each cable and if I used the wrong one I would get connection break error. Mine came with 2 boards, one for Thunder Power and one for whatever most other batteries use, including E-Sky. I had to rewire the balance connector.It was a 5 pin connector on a 3S lipo with one space skipped, why the battery was wired like that I dont know but I eliminated the space and it worked.Īlso, if any cell in your battery is over charged (above 4.21v) or over discharged (belowģv, I think) the charger will give you an error and not work. Having tried and re-tried the connections over and over to no success, Ive come to the conclusion that this sport is a taxing sport. With the battery firmly connected to the proper socket (4 posts and also polarized), i start the charge by holding the STARTENTER button down for 3 seconds.Ī BATTERY CHECK message is displayed and within seconds the unit is beeping with a CONNECTION BREAK message.ĬONNECTION BREAK seems to imply an interruption between the battery and the unit. In addition, the receptors on both the mother unit and the daughter board are also polarized. Regardless, the connection appear quite straightforward with the cable having a polarized ends. Make sure you select the right cell count and charge current.Īs usual, there is no documentation regards making this connection so to some extent Im on my own (heres where you get involved). I'll be very pleased if you can help me.Rc Power Bc6 User Manual By genonarco1980 Follow | Public To open the charger is very easy you just need get of the screws beside and of the fan and a trick is get of also those blue pins wich we choose the function, get of then with the pliers. So, the picture is there and those IC's marked with red square are burned, I can change those if I have their reference but after burned I can't see. So strange, here is good because we can exchange experiences like that. Those charger are very strange, have you tried to see the current potency on each cell if is really ballancing, I've tried many times when the balance function was working well but It was always unbalanced. But it's faster than when it's charging and balancing. It's not funny, I read about your problem and I have some problem with my charger, when I'm charging in normal mode, without balance the Discharge goes down, until it charge everything. Thanx GOD, you sent someone to help me! KKkK.įriend, I haven't used my charger since I burned those IC, It's working like I said but without balance function.
0 kommentar(er)
